Service Bed w/IMT Crane Utility Body
- Tuesday, April 14, 2026 (Start)
- Tuesday, April 21, 2026 (End)
- Status: Pending
IMT 3820 Dominator hydraulic telescopic crane from Iowa Mold Tooling (IMT) designed for material handling on service trucks. It features a maximum lifting capacity of 7,500 lbs. (3.75 tons) and is typically rated at 38,000 ft-lb.
Key Specifications
- Maximum Lift Capacity: 7,500 lbs (3,402 kg).
- Crane Rating: 38,000 ft-lb (5.25 ton-meters).
- Horizontal Reach: Approximately 20' 6" (6.25 m).
- Rotation: 400° or 450° depending on the specific model year/configuration.
- Winch Speed: Single line winch speed is approximately 60 fpm (no load), while some variants offer two-speed options (34 ft/min high, 17 ft/min low under load).
- Control System: Often equipped with a fully proportional "pistol grip" radio remote or a 30-foot wired remote control.
Operational Features
- Boom Design: Features a hexagonal or "Penta Boom" design for enhanced strength and control during operation.
- Safety Systems: Includes an Anti-Two Block device to prevent the hook assembly from contacting the boom tip and a standard rated capacity limiter (RCL) system.
NOTE: Truck was not running when pulled - not been operationally tested. Being sold as/is w/NO RESERVE!
Service Bed w/Summit Crane Utility Body
- Tuesday, April 14, 2026 (Start)
- Tuesday, April 21, 2026 (End)
- Status: Pending
Utility body/service bed w/Summit 6620 crane ~ Includes controller; all functions tested good
'76 GMC Sq Body Pickup 4x4
- Tuesday, April 14, 2026 (Start)
- Tuesday, April 21, 2026 (End)
- Status: Pending
VIN: TKL246J501658 lock-out 4x4 hubs, 350 cid engine, 4 barrel, 4-spd. trans. 3/4 ton 4WD pickup
'12 Ram 5500 Service Truck w/Summit 6620 Crane
- Tuesday, April 14, 2026 (Start)
- Tuesday, April 21, 2026 (End)
- Status: Pending
SALVAGE TITLE, NO MOTOR, NO TRANS. GOOD UTILITY BODY/CRANE ~ Being sold as/is w/NO RESERVE!
Year: 2012
Make: Ram
Model: 5500 Chassis
Vehicle Type: Truck
Mileage: Unknown
Body Type: 2 Door Cab; Regular
Trim Level: ST; SLT; Tradesman; Laramie
Drive Line: 4WD; Dual Rear Wheels
Engine: NONE
Transmission: NONE
VIN #: 3C7WDNBL5CG233541
Salvage Title; no motor, parts shown are included. Good utility body/service bed with Summit 6620 crane
'08 Ford F-450 Service Truck
- Tuesday, April 14, 2026 (Start)
- Tuesday, April 21, 2026 (End)
- Status: Pending
Year: 2008
Make: Ford
Model: F-450
Vehicle Type: Pickup Truck
Mileage: shows 197k miles - Runs and drives - Being sold as/is w/NO RESERVE!
Body Type: 2 Door Cab; Regular; Chassis
Trim Level: XL
Drive Line: RWD; Dual Rear Wheels
Engine Type: V10, 6.8L; EFI
Fuel Type: Gasoline
Horsepower: 305HP
Transmission: Automatic
VIN #: 1FDXF46YX8EC79467
'06 Vanair Viper G70 Air Compressor; Kohler EFI; Low Hours; 70 CFM
- Tuesday, April 14, 2026 (Start)
- Tuesday, April 21, 2026 (End)
- Status: Pending
Kohler gas motor with EFI shows 1,232 hours; high pressure on-demand rotary screw compressor mfg. 02/2006, Vanair by Sullair
'94 Pontiac Firebird 25th Anniversary Trans Am
- Tuesday, April 14, 2026 (Start)
- Tuesday, April 21, 2026 (End)
- Status: Pending
Year: 1994
Make: Pontiac
Model: Firebird
Vehicle Type: Passenger Car
Mileage: 56k
Body Type: 2 Door Coupe
Trim Level: Formula; Trans Am
Drive Line: RWD
Engine Type: V8, 5.7L (350 CID)
Fuel Type: Gasoline
Transmission: Automatic
VIN #: 2G2FV22P3R2244372
Features and Notes: Corvette LT1 built by performance shop (see photos of Dyno sheets), Corvette wheels, smoked glass T-Tops,
Powerhouse Generator
- Tuesday, April 14, 2026 (Start)
- Tuesday, April 21, 2026 (End)
- Status: Pending
PH2400Pi generator BCN # 17122040009430007
Powerhouse Generator
- Tuesday, April 14, 2026 (Start)
- Tuesday, April 21, 2026 (End)
- Status: Pending
PH2400Pi generator BCN # 1712204009430012
Downspouts, Elbows 4x5 Entire Lot
- Tuesday, April 14, 2026 (Start)
- Tuesday, April 21, 2026 (End)
- Status: Pending
4" x 5" downspouts approx. 10 1/2' sticks, elbows +/-5 qty.
Coleman Powermate Maxa Generator
- Tuesday, April 14, 2026 (Start)
- Tuesday, April 21, 2026 (End)
- Status: Pending
4k watt gasoline generator
Kawasaki KLX 230 RS Dirt Bike
- Tuesday, April 14, 2026 (Start)
- Tuesday, April 21, 2026 (End)
- Status: Pending
Like NEW - 10 hours!
Beta 350 HT Dirt Bike
- Tuesday, April 14, 2026 (Start)
- Tuesday, April 21, 2026 (End)
- Status: Pending
Like New 6.2 hours!
John Deere 570A Grader/Blade
- Tuesday, April 14, 2026 (Start)
- Tuesday, April 21, 2026 (End)
- Status: Pending
3,800 hours
National Crane Outer Section 23'
- Tuesday, April 14, 2026 (Start)
- Tuesday, April 21, 2026 (End)
- Status: Pending
good newer piece of steel off of National crane; approx. 15" x 11" x 23' long
Entire Pallet
- Tuesday, April 14, 2026 (Start)
- Tuesday, April 21, 2026 (End)
- Status: Pending
CAT Fuel Pump NEW in Crate
- Tuesday, April 14, 2026 (Start)
- Tuesday, April 21, 2026 (End)
- Status: Pending
Caterpillar Tier 4 injection pump CAT part number: 5740991 NEW in crate (1st photo is STOCK PHOTO, as this is unopened in crate).
574-0991 Genuine CAT High Pressure Fuel Pump
This high pressure fuel pump from CAT is designed to deliver reliable performance and durability.
Key Features
- Designed to match or exceed applicable specifications
- Provides the function required for the intended system or assembly
- Built for dependable performance and service life
- Backed by CAT quality and engineering.
Specifications
| Brand | CAT |
| Part Type | High Pressure Fuel Pump |
| SKU | 574-0991 |
| OEM Cross Reference | 713305AT Fits On: Petroleum Engine 3512E, 2016. Engine 3512E. Pumper SPF743 |
| UPC | 713305AT |
| Weight | 400.0 lb |
Brand: CAT
Entire Pallet
- Tuesday, April 14, 2026 (Start)
- Tuesday, April 21, 2026 (End)
- Status: Pending
Perkins Engine 4.233L
- Tuesday, April 14, 2026 (Start)
- Tuesday, April 21, 2026 (End)
- Status: Pending
4.233L diesel engine out of a fork lift; Perkins 3PKXL04.2AR1; ran when removed.
Cummins K19 Diesel Engine
- Tuesday, April 14, 2026 (Start)
- Tuesday, April 21, 2026 (End)
- Status: Pending
New rods/bearings, compression rings, heads tested good
- Engine Type: 4-stroke, Inline 6-cylinder, Diesel
- Displacement: 19 Liters (1,150 cid)
- Power Output: 450 – 700+ HP (336 – 522 kW)
- Applications: Mining (haul trucks, excavators), Construction, Marine, Power Generation
- Key Features: Mechanical Cummins PT® fuel system, turbocharger/aftercooler, optional CENTRY™ electronics
- Weight: ~1634kg (over 4,000 lbs)
Pair Diamond Plate Guards
- Tuesday, April 14, 2026 (Start)
- Tuesday, April 21, 2026 (End)
- Status: Pending
two (2) this lot; off of trailer
'07 Peterbilt 379 Truck
- Tuesday, April 14, 2026 (Start)
- Tuesday, April 21, 2026 (End)
- Status: Pending
Year: 2007
Make: Peterbilt
Model: 379
Vehicle Type: Truck
Mileage: shows 31k*
Body Type: Day Cab
Drive Line: 6x4
Engine Type: L6, 15.2L (927 CID)
Fuel Type: Diesel
Transmission:
VIN #: 1XP5DB9X67D668019
*2007 Peterbilt ~ 250k miles on CAT C15 rebuild ~ seller backs it up with 90-day warranty on rebuilt engine; truck has wet kit installed, new fan and radiator, new clutch a year and a half ago, new radiator and engine mounts
NEW Tier 4 CAT Turbo
- Tuesday, April 14, 2026 (Start)
- Tuesday, April 21, 2026 (End)
- Status: Pending
Tier 4 Caterpillar turbo - NEW in box (1st photo is STOCK PHOTO, as this is unopened in box)
Information Lot
- Saturday, May 2, 2026 (Start)
- Saturday, May 9, 2026 (End)
- Status: Pending
Information Lot
- Tuesday, April 14, 2026 (Start)
- Tuesday, April 21, 2026 (End)
- Status: Pending
'11 Chevrolet Silverado Pickup Truck
- Tuesday, April 14, 2026 (Start)
- Tuesday, April 21, 2026 (End)
- Status: Pending
Rebuilt LML Duramax engine, new turbo, injectors, heads, and bearings READY FOR INSTALL included with purchase of truck. NOTE: REBUILT ENGINE IS INCLUDED WITH TRUCK - NOT INSTALLED.
Year: 2011
Make: Chevrolet
Model: Silverado
Vehicle Type: Pickup Truck
Mileage:
Body Type: 4 Door Cab; Crew
Trim Level: LT
Drive Line: 4WD
Engine Type: Rebuilt (out of truck -included) LML 6.6L Duramax
Fuel Type: Deisel
Transmission: Allison 6-spd. automatic
VIN #: 1GC1KXC89BF113275
Log Splitter
- Tuesday, April 14, 2026 (Start)
- Tuesday, April 21, 2026 (End)
- Status: Pending


